Refine
Year
- 2016 (19) (remove)
Publication Type
- Conference Proceeding (9)
- Article (3)
- Book (3)
- Master's Thesis (2)
- Bachelor Thesis (1)
- Report (1)
Has Fulltext
- yes (19) (remove)
Keywords
- Hochschulorganisation (2)
- Management (2)
- Prozessmanagement (2)
- Behavioral Management (1)
- Big Data (1)
- Bitcoin (1)
- Clearinghouse-Anwendung (1)
- Containerschiff (1)
- Containerterminal (1)
- Dokumentenmanagement (1)
Power: the missing element in sustainable consumption and absolute reductions research and action
(2016)
In this essay, we aim to demonstrate the value of a power lens on consumption and absolute reductions. Specifically, we illuminate what we perceive to be a troublesome pattern of neglect of questions of power in research and action on sustainable consumption and absolute reductions. In pursuit of our objectives, we delineate how many of the informal and implicit “theories of social change” of scholars and activists in sustainable consumption and sustainable development fail to address power in a sufficiently explicit, comprehensive and differentiated manner and how that failure translates into insufficient understandings of the drivers of consumption and the potential for and barriers to absolute reductions. Second, we develop the contours of a power lens on sustainable consumption. Third, we illustrate the value of such a power lens, with a particular focus on the case of meat consumption.
For long term use of dams, it is required to develop methods of sediment management in reservoirs.
As one method, Sediment BypassTunnels (SBT) are operated in Japan and Switzerland to prevent reservoir sedimentation. SBT reduces sedimentation in reservoirs by routing the incoming sediments around the dam. SBT, however, is prone to severe invert abrasion caused by high sediment flux. Therefore, it is necessary to establish a measurement system of sediment transport rates in the SBT. A geophone was experimentally investigated in a laboratory flume at ETH Zurich. The sediment transport rate is calculated based on the plate vibration caused by hitting of gravels. In this paper, in order to alleviate disadvantages of a geophone, two newly developed sensor systems, a plate microphone and plate vibration sensor, are suggested and the results of their calibration experiments are shown. Finally, they are compared with the existing methods.
To understand the effects of sediment bypass on environmental recovery of the degraded channels below dams, bed topography and bed materials above and below dam reaches were surveyed by ground-based measurements and aerial photos using quadrocopter. Coarse bed materials such as boulders were more represented below than above the Koshibu dam, where the bypass tunnel had not been in operation yet. The coarse materials formed steps and protruded in the water column within riffles and runs, both of which can increase slow-flow areas, below the dam. On the other hand, sand, gravel, and cobbles were abundant below as much as above the Asahi dam, where the bypass tunnel had been operated for >17 years. The downstream environment in terms of bed topography and grain size seems to have almost been recovered for the Asahi dam. However, less representation of large cobbles and boulders below the dam suggested a possibility of a selective deposition of coarse materials at the upstream of the bypass tunnel inlet.
Positive effects of reservoir sedimentation management on reservoir life: Examples from Japan
(2016)
The effectiveness of different strategies against reservoir sedimentation is demonstrated herein using data sets of Asahi, Nunobiki and Dashidaira reservoirs in Japan. The applied strategies encompass
sediment routing with a bypass tunnel, drawdown flushing during floods and sabo dam construction in the catchment. It is shown that bypassing and flushing are very efficient strategies enlarging reservoir life by 3 to 21 times up to many hundreds of years. Furthermore, it is revealed that also efforts in the catchment, e.g. sabo dam construction, is effective enlarging reservoir life by 2.4 times.
Sediment Bypass Tunnels are operated to divert sediment around reservoirs reducing reservoir sedimentation. A major drawback of these tunnels is severe invert abrasion due to high velocity and sediment flows. There is an urgent need to establish innovative measurement systems of sediment transport rates in SBTs. In this paper, three bedload measuring systems, namely hydrophones, geophones, and newly developed plate microphones are introduced and compared. The Koshibu SBT is planned to operate from 2016. Plate microphones combined with geophones and other planned systems are installed in the tunnel. Results of preliminary tests and installation plans of bedload
measurement are presented.
Sediment bypass tunnels are an effective and sustainable strategy against reservoir sedimentation. Sediments are diverted into the down-stream during floods without deposition in the reservoir, hence mor-phological and ecological variability increases. One major drawback of these tunnels is the severe invert abrasion due to a combination of high flow velocities and bedload sediment transport. The abrasion phenom-ena is briefly described, different abrasion prediction models are pre-sented and their applicability for the estimation of concrete abrasion is discussed.
Sediment, which deposits and damages the function of reservoirs, is an essential element of aquatic habitats in downstream ecosystems. We reviewed ecosystem features of degraded channels associated with sediment deficiency below dams and ecosystem responses to changes in sediment conditions after management practices in Japan. Sediment bypass tunnel (SBT) is an effective way to transport sufficient amount of sediment to downstream ecosystems. Based on a concept of suitable mass and size of sediment for ecosystem, some effects and limitations of SBT on downstream ecosystems were discussed.
We have developed and manufactured a unimorph deformable mirror for space telescopes based on piezoelectric actuation. The mirror features 44 actuators, has an aperture of 50 mm, and is designed to reproduce low-order Zernike modes with a stroke of several tens of µm. We assessed the space compliance by operating the mirror in thermal vacuum, and exposing it to random and sinusoidal vibrations, as well as to ionizing irradiation. Additionally, the operational life time and the laser power handling capability were tested. The mirror was successfully operated in thermal vacuum at 100 K. We report on the conducted tests and the methods used to evaluate the mirror´s performance, and discuss the compliance with the demanded requirements
Von Januar bis März 2015 wurde eine Umfrage an deutschen Hochschulen durchgeführt, um den aktuellen Entwicklungs- und Einführungsstand von Dokumentenmanagementsystemen (DMS) an deutschen Hochschulen zu erheben. Dabei standen unter anderem folgende zentrale Fragestellungen im Vordergrund: wer nutzt aktuell bereits Dokumentenmanagementsysteme und warum (nicht), welche Aufgaben werden mit dem System unterstützt, welche konkrete Software wird eingesetzt und welche Herausforderungen und Erfolgsfaktoren existieren bei der Einführung von Dokumentenmanagementsystemen? Die Studie soll unter anderem Hochschulen als Informations- und Diskussionsgrundlage in eigenen DMS-Einführungsprojekten dienen.