open_access
Refine
Publication Type
- Article (22)
- Report (13)
- Conference Proceeding (2)
- Part of Periodical (2)
- Bachelor Thesis (1)
Language
- English (40) (remove)
Keywords
- wind turbine (4)
- renewable energy (3)
- energy system modeling (2)
- offshore wind turbines (2)
- wind energy (2)
- wind power (2)
- Alden turbine (1)
- Big bubble curtain (1)
- Circular economy (1)
- DWA-M 509 (1)
Faculty
- Energie · Gebäude · Umwelt (EGU) (40) (remove)
The Educational Journal of Renewable Energy Short Reviews (EduJRESR, formally published as `EGU Journal of Renewable Energy Short Reviews') is a teaching project rather than a regular scientific journal. To publish in this journal, it is a premise to take part in the master course wind power, hydro power and biomass usage at the department of Energy, Building Services and Environmental Engineering of the Münster University of Applied Sciences.
Students receive an equivalent of 2.5 credit points (European Credit Transfer and Accumulation System - ECTS) for their engagement in the course and for publishing a short review article of at most 3000 words in this periodical. The publication process closely mimics the typical publication procedure of a regular journal. The peer-review process, however, is conducted within the group of course-participants.
Although being just an exercise, we think that publishing the outcome of this course in a citable manner is not only promoting the motivation of our students, but may also be a helpful source of introductory information for researchers and practitioners in the field of renewable energies. We encourage students to write their articles in English, but this is not mandatory. The reader will thus find a few articles in German language. To further encourage students practicing English writing, perfect grammar is not part of the assessment.
We especially thank our students for working with LaTeX on Overleaf, although LaTeX is new to some of them. In this way, the editorial workload was reduced to a minimum. We also thank our students for sharing their work under the creative commons attribution licence (CC-BY). We appreciate their contribution to scientific information, being available to every person of the world, almost without barriers. We also thank the corresponding authors and publishers of the cited work, for granting permission to reuse graphics free of charge. All other figures had to be replaced or removed prior to publication.
The Educational Journal of Renewable Energy Short Reviews (EduJRESR, formally published as ‘EGU Journal of Renewable Energy Short Reviews’) is a teaching project rather than a regular scientific journal.
To publish in this journal, it is a premise to take part in the master course wind power, hydro power and biomass usage at the department of Energy, Building Services and Environmental Engineering of the Münster University of Applied Sciences.
Students receive an equivalent of 2.5 credit points (European Credit Transfer and Accumulation System – ECTS) for their engagement in the course and for publishing a short review article of at most 3 000 words in this periodical. The publication process closely mimics the typical publication procedure of a regular journal.
The peer-review process, however, is conducted within the group of course-participants.
Although being just an exercise, we think that publishing the outcome of this course in a citable manner is not only promoting the motivation of our students, but may also be a helpful source of introductory information for researchers and practitioners in the field of renewable energies. We encourage students to write their articles in English, but this is not mandatory. The reader will thus find a few articles in German language.
To further encourage students practicing English writing, perfect grammar is not part of the assessment.
We especially thank our students for working with LATEX on Overleaf, although LATEX is new to some of them. In this way, the editorial workload was reduced to a minimum. We also thank our students for sharing their work under the creative commons attribution licence (CC-BY). We appreciate their contribution to scientific information, being available to every person of the world, almost without barriers. We also thank the corresponding authors and publishers of the cited work, for granting permission.
Meanwhile, renewable energy sources such as hydropower, solar and wind energy and biomass are increasingly being used to reduce dependence on fossil fuels and thus counteract the ongoing global warming. However, these are also associated with environmental impacts. To that effect, this article takes a closer look at tidal power plants, which are classified as hydroelectric power plants, by conducting a systematic literature review. The results show that the strength and form of the environmental impact depends on the specific location and type of plant. Tidal power plants have an impact on the habitats of marine animals and thus influence their behavior and population. In addition, the operation of tidal power plants changes the sediment distribution, causes a reduction in current velocities and a change in current direction in the surrounding area and leads to a change in wave height. The construction of the power plants is associated with noise, which primarily causes changes in the behavior of some species. Furthermore, the electromagnetic fields generated can also affect marine life. In order to assess the environmental impact of tidal power plants in comparison to other renewable energies, further studies should focus on the environmental impact of the different technologies in relation to the energy yield.
This article discusses the use of artificial intelligence
in the wind energy industry, particularly in addressing
challenges and optimizing the expansion of renewable
energies in Germany. It highlights the application
of artificial intelligence in wind forecasts and yield
predictions, bird detection, wind turbine and farm
design, condition monitoring, and predictive maintenance.
Additionally, it introduces the “WindGISKI”
research project, which aims to use artificial intelligence
to identify new areas for wind turbines. The
project utilizes a neural network to analyze and predict
flight routes, potentially reducing bird mortality.
The document also emphasizes the potential broader
applications of “WindGISKI” in other fields of activity,
such as land use planning and city development.
Overall, it underscores the significant role of artificial
intelligence in addressing challenges in wind energy
and outlines the potential for artificial intelligence
to drive the expansion of renewable energies while
addressing key obstacles.
Wind turbine structures take a major role in the
modern conversion to renewable energy sources and
contribute to the creation of a greener world. In recent
years, the development and installation of wind
turbines have seen rapid growth. However, with the
increasing capacity and size of wind farms worldwide,
there are growing concerns about the safety and reliability
of these installations. Therefore, structural
health monitoring and the detection of damage to
wind turbines have gained considerable importance in
research. Wind turbine blades are particularly susceptible
to various types of damage due to environmental
influences. This article provides an overview of signal
responses, sensors used and non-destructive testing
techniques in the field of damage detection on wind
turbine blades. The intention of the article is to give
an insight into the possibilities of structural health
monitoring and at the same time to point out unsolved
problems in this field.
The global salinity gradient power (SGP) potential is between 1650 - 2000 TWH/a and can be converted by mixing two solutions with different salinities. The harnessing of SGP for conversion into power can be accomplished by means of pressure retarded osmosis (PRO) and reverse electrodialysis (RED). PRO and RED are membrane-based technologies and have different working principles. PRO uses a semipermeable membrane to seperate a concentrated salt solution from a diluted solution. The diluted solution flows through the semipermeable membrane towards the concentrated solution, which increases the pressure within the concentrated solution chamber. The pressure is balanced by a turbine and electricity is generated. RED uses the transport of ions through cation and anion exchange membranes. The chambers between the membranes are alternately filled with a concentrated and diluted solution. The salinity gradient difference is the driving force in transporting ions that results in an electric potential, which is then converted to electricity. The comparison shows that there are two different fields of application for PRO and RED. PRO is especially suitable at extracting salinity energy from large concentration differences. In contrast, RED are not effect by increasing concentration differences. So PRO are supposed to focus on applications with brines or waste water and RED on applications with river water and seawater. Moreover, just a few measured values from processes under real conditions are available, which makes it difficult to compare PRO and RED.
For the increasingly important storage of renewably generated electricity, this review explains the construction of a surface and underground pumped storage
power plant. The problems for the construction of an underground pumped storage power plant are further listed. These are geological, environmental and
economic problems as well as a low acceptance by the population. The geological problems are concerns about leaching of minerals and heavy metals as well as the statics of the cavities. Mining companies in Germany are obligated to renaturalize the landscape areas again, which could be realised by a lake. Furthermore, care must be taken to ensure that the mine water does not come into contact with the groundwater. According to a survey by RISP on the subsequent use of the mine areas for an underground pumped
storage power plant, the acceptance of the population is over 70 percent. The economic consideration concludes that the arbitrage profit for a difference between off-peak and peak of 10 €/MWh is about 2.7 M€/a and for 100 €/MWh about 27.3 M€/a. With investment costs of about 630 M€, despite the assumption of 100 €/MWh, more than 20 years are needed for an underground pumped storage power plant to be amortized. The acceptance could be increased by creating a lake as a recreation area as well as being used as an upper storage reservoir. Thus, the cost of renaturation decrease when combined with the creation of the storage basin. The problem of ground conditions can be solved by creating new cavities by means of tunnel boring at an inclination. For static safety as well as against leaching of minerals and heavy metals, the cavity walls can be sealed with reinforced concrete. The technology of underground pumped storage power plants can be used for better utilisation of renewable energies. This is especially in flat and densely populated regions a possibility to store energy, because the main part of the power plant is underground.
The preservation of water bodies continuity is fundamental
for aquatic communities, particularly for fish
populations. Various structures impede watercourse
continuity, impacting fish migration and habitat distribution.
Conventional fish passages often fall short
in diverse scenarios, prompting the development of
specialized solutions. This article proposes a criteria
catalog for these special fish passage solutions based
on DWA leaflet DWA-A 509. It discusses the need
for these solutions, presents a selection of specialized
options, and outlines criteria from DWA-M 509, construction
guidelines, and economic perspectives. It
scrutinizes criteria ranging from target fish species to
cost considerations. Three examples, including the
Runserau fish lift, the bristle ramp fish lock, and the
Fishcon sluice, illustrate these specialized solutions,
their functionalities, advantages, and drawbacks. Additionally,
the article compiles criteria from industry
standards and guidelines into a comprehensive evaluation
catalog. The criteria, when applied, assist in the
selection of suitable fish passage solutions based on
specific site conditions and fish species requirements.
This holistic approach aims to optimize fishway selection,
fostering the ecological sustainability of watercourses.
However, this catalog remains dynamic
and open to expansion with evolving research and
practical application, urging further exploration and
validation of these criteria through diverse case studies
and technological advancements in the field.
The use of wind power is rapidly expanding worldwide. It is important to examine the impact of wind turbines on the environment to see if they provide a net benefit and to identify potential for improving. Therefore life cycle assessments (LCA) of different wind turbine types are compared in this short review. The results are then shown side by side in tables for comparison. Overall the LCAs show that wind turbines compensate the required energy and emitted pollutants after approx. 6-16 months. The energy payback period (EPP) for 2 MW onshore wind turbines remained roughly the same since 2009 with approximately 7 months. Onshore wind turbines have a higher impact due to emissions but a shorter EPP than offshore wind turbines. The estimated service life of 20 years should be maximized to ensure a high energy yield ratio. The biggest impact on the environment results from the processes to provide the building material e.g. steel and cement. That impact could be reduced by 20 % if recycled steel would be used. It is shown that wind power is one of the cleanest energy sources. But further investigations in material processing and recycling are important to improve the eco-balance of wind turbines.