TY - CHAP A1 - Wittrock, Ulrich A1 - Welp, Petra T1 - Adaptive laser resonator control with deformable MOEMS mirrors T2 - MEMS/MOEMS Components and Their Applications III, Proc. SPIE N2 - Adaptive laser resonators with deformable MOEMS mirrors under closed-loop control are discussed and experimental results are presented. The requirements for deformable mirrors and for closed-loop control systems of these mirrors are analyzed. Several deformable mirrors have been characterized and the results are presented. Currently available membrane mirrors deform under laser load and need further development before they can be used for aberration correction of solid state lasers above some tens of Watts. Nevertheless, the results are encouraging and the requirements are within reach of currently available technology. Finally, we demonstrate an Nd.YVO4-laser with a closed-loop adaptive resonator and more than 6 W of output power. The closed-loop system was able to compensate artificially introduced aberrations from a phase plate. Y1 - 2006 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6537 VL - 6113 SP - 61130C PB - SPIE ER - TY - JOUR A1 - Wittrock, Ulrich A1 - Vorholt, Christian T1 - Spatial hole burning in Yb:YAG thin-disk lasers JF - Appl. Phys. B N2 - The spatially varying intensity in a standing wave resonator leads to spatial hole burning in the gain medium of a laser. The spatial hole burning changes the gain of different longitudinal modes and can thus determine the optical spectrum of the laser. We simulate this longitudinal mode competition in standing wave resonators of thin-disk lasers. The resulting optical spectra of the laser are compared to measured optical spectra. We examine two types of resonators: I-resonators and V-resonators with different angles of incidence. In V-resonators, the non-normal incidence of the laser beam on the disk lifts the degeneracy of the polarization. Experiments show that the slight gain advantage for the p-polarization does not lead to polarized emission. For both types of resonators, the measured spectra are in good agreement with the simulated ones. The simulations allow to study the influence of spectral intra-cavity losses on the optical spectrum of a thin-disk laser. Y1 - 2015 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-8234 VL - 120 SP - 711 EP - 721 ER - TY - JOUR A1 - Vorholt, Christian A1 - Wittrock, Ulrich T1 - Single-frequency oscillation of thin-disk lasers due to phase-matched pumping JF - Opt. Expr. N2 - We present a novel pump concept that should lead to single-frequency operation of thin-disk lasers without the need for etalons or other spectral filters. The single-frequency operation is due to matching the standing wave pattern of partially coherent pump light to the standing wave pattern of the laser light inside the disk. The output power and the optical efficiency of our novel pump concept are compared with conventional pumping. The feasibility of our pump concept was shown in previous experiments. KW - diode-pumped laser KW - solid-state laser KW - ytterbium laser Y1 - 2017 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-10258 VL - 25 SP - 21388 EP - 21399 ER - TY - CHAP A1 - Verpoort, Sven A1 - Wittrock, Ulrich T1 - Novel unimorph deformable mirror with monolithic tip-tilt functionality for solid state lasers T2 - MEMS Adaptive Optics V, Proc. SPIE N2 - We present a new type of unimorph deformable mirror with monolithic tip-tilt functionality. The tip-tilt actuation is based on a spiral arm design. The mirror will be used in high-power laser resonators for real-time intracavity phase control. The additional tip-tilt correction with a stroke up to 6 μm simplifies the resonator alignment significantly. The mirror is optimized for a laser beam footprint of about 10 mm. We have modeled and optimized this mirror by finite element calculations and we will present design criteria and tradeoffs for this mirrors. The mirror is manufactured from a super-polished glass substrate with very low surface scattering and excellent dielectric coating. Y1 - 2011 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6471 VL - 7931 SP - 793107 PB - SPIE ER - TY - CHAP A1 - Verpoort, Sven A1 - Wittrock, Ulrich T1 - Unimorph deformable mirror for telescopes and laser applications in space T2 - International Conference on Space Optics (ICSO), Rhodes Island, Greece N2 - Over the past 5 years we have developed a new type of unimorph deformable mirror. The main advantages of this mirror technology are · very low surface scattering due to the use of superpolished glass · excellent coatings, even suitable for high power lasers, can be applied · active diameter of the mirrors can be between 10 mm and 100 mm · large strokes can be achieved even for small mirror diameters · integrated monolithic tip/tilt functionality based on a spiral arm design We have modeled these mirrors by analytical models as well as by the finite element method. This allows us to quickly design new mirrors tailored to specific applications. One example is a mirror for laser applications that has a diameter of 10 mm and can achieve a stroke in defocus mode of 5 μm. The stroke for these mirrors scales as the square of the mirror diameter, meaning that we can achieve, for example, a stroke of 125 μm for a mirror of 50 mm diameter. We will present design criteria and tradeoffs for these mirrors. We characterize our mirrors by the maximum stroke they can deliver for various Zernike modes, under the boundary condition that the Zernike mode has to be created with a certain fidelity, usually defined by the Maréchal criterion. Y1 - 2010 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6484 UR - www.icsoproceedings.org PB - SPIE ER - TY - JOUR A1 - Verpoort, Sven A1 - Wittrock, Ulrich T1 - Actuator patterns for unimorph and bimorph deformable mirrors JF - Appl. Opt. N2 - The actuator pattern of an adaptive mirror determines the amplitudes and the fidelities of the mirror deformations that can be achieved. In this study, we analyze and compare different electrode patterns of piezoelectric unimorph deformable mirrors using a numerical finite element model. The analysis allows us to determine the optimum actuator pattern, and it is also applicable to bimorph mirrors. The model is verified by comparing its predictions with experimental results of our prototype of a novel unimorph deformable mirror. Y1 - 2010 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6490 UR - http://www.opticsinfobase.org VL - 49 SP - G37 EP - G46 PB - OSA ER - TY - CHAP A1 - Verpoort, Sven A1 - Welp, Petra A1 - Wittrock, Ulrich T1 - Novel unimorph deformable mirror for solid state laser resonators T2 - MEMS Adaptive Optics III, Proc. SPIE N2 - We present a novel unimorph deformable mirror with a diameter of only 10 mm that will be used in adaptive resonators of high power solid state lasers. The relationship between applied voltage and deformation of a unimorph mirror depends on the piezoelectric material properties, layer thicknesses, boundary conditions, and the electrode pattern. An analytical equation for the deflection of the piezoelectric unimorph structure is derived, based on the electro-elastic and thin plate theory. The validity of the proposed analytical model has been proven by numerical finite-element modelling and experimental results. Our mirror design has been optimized to obtain the highest possible stroke and a high resonance frequency. Y1 - 2009 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6504 VL - 72090N PB - SPIE ER - TY - CHAP A1 - Verpoort, Sven A1 - Rausch, Peter A1 - Wittrock, Ulrich T1 - Novel unimorph deformable mirror for space applications T2 - International Conference on Space Optics (ICSO), Proc. SPIE N2 - We have developed a new type of unimorph deformable mirror, designed to correct for low-order Zernike modes. The mirror has a clear optical aperture of 50 mm combined with large peak-to-valley Zernike amplitudes of up to 35 μm. Newly developed fabrication processes allow the use of prefabricated super-polished and coated glass substrates. The mirror's unique features suggest the use in several stronomical applications like the precompensation of atmospheric aberrations seen by laser beacons and the use in woofer-tweeter systems. Additionally, the design enables an efficient correction of the inevitable wavefront error imposed by the floppy structure of primary mirrors in future large space-based telescopes. We have modeled the mirror by using analytical as well as finite element models. We will present design, key features and manufacturing steps of the deformable mirror. Y1 - 2012 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6516 UR - https://www.spiedigitallibrary.org/conference-proceedings-of-spie/10564/1056414/Novel-unimorph-deformable-mirror-for-space-applications/10.1117/12.2309089.full VL - 10564 SP - 1056414-1 PB - SPIE ER - TY - JOUR A1 - Vennemann, Peter T1 - Zukunft der Stromspeicherung in Pumpspeicherkraftwerken T1 - Future of Energy-Storage with Pumped Hydro Power JF - Deutsches Ingenieurs-Blatt N2 - Mit wenigen Ausnahmen wird im elektrischen Versorgungssystem die Pumpspeichertechnik zur Pufferung größerer Abweichungen zwischen momentanem Stromverbrauch und -erzeugung und zur zeitlichen Verschiebung von Lasten eingesetzt. Erste großtechnische Anlagen wurden bereits Ende der zwanziger Jahre des letzten Jahrhunderts in Deutschland gebaut, um die Auslastung thermischer Kraftwerke gleichmäßiger zu ermöglichen. Pumpspeicherwerke bieten sich somit als Referenztechnologie an, mit der sich neue Entwicklungen messen müssen. Ein Überblick. N2 - Pumped hydro power is the first choice for buffering larger deviations between supply and demand of electricity. In Germany, first plants were build in the late nineteen-twenties. Pumped hydro power can be used as a reference technique for emerging technologies for electricity storage. The article gives an introduction into the pumped hydro power technology. KW - Energiewirtschaft KW - Energieversorgung KW - Wasserkraft KW - Pumpspeicher Y1 - 2014 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-6954 VL - 2014 IS - 3 ER - TY - THES A1 - Schultealbert, Susanne T1 - Wasser- und Sanitärversorgung von Schulen und Gesundheitsstationen für exemplarische Fälle im ländlichen Raum Äthiopiens T1 - Example of water and sanitation facilities for schools and health facilities in rural Ethiopia N2 - Eine besonders von Wassermangel betroffene Region ist das Bundesland Afar im Nordosten Äthiopiens. In diesem Gebiet befindet sich das Dorf Hidmo. Mittels Geldern aus der Entwicklungshilfe hat die äthiopische Regierung dort ein Schulgebäude errichten lassen, damit die Kinder aus der Umgebung der allgemeinen Schulpflicht nachkommen können. Es wurde aber vergessen, Geld für eine Wasser-und Sanitärversorgung einzuplanen, diese wäre notwendig, da die nächste Wasserstelle 500 m weit entfernt ist. Im Rahmen dieser Arbeit soll auf Vorplanungsniveau untersucht werden, inwiefern es möglich ist, Niederschlagswasser zu speichern, welches den Schülern als Wasserquelle dient und welche Sanitärsysteme dafür in Frage kommen. Zum einen sollen diese das Ausbreiten von Krankheiten verhindern und zum anderen die knappe Ressource Wasser schonen. Zusätzlich soll versucht werden, Bewässerungswasser bereit zu stellen, zur Bewässerung eines schuleigenen Nutzgartens, der dazu dienen soll, die Kinder in sparsamen Bewässerungsmethoden zu schulen. Der Wasserspeicher soll nur Brauchwasser zum Händewaschen und zu Bewässerungszwecken liefern. Trinkwasser soll mittels einer Rohrleitung aus der vorhandenen, 500m von der Schule entfernten, Wasserquelle bezogen werden. Zur Auswahl sollen nur angepasste Technologien kommen, vorwiegend einfach gehalten, dem Prinzip der Kreislaufwirtschaft nahekommend. N2 - A model water and sanitation concept was developed for being used in a primary school of the village of Hidmo in the arid Ethiopian Province of Afar. KW - Trinkwasserversorgung KW - Abwasserbeseitigung KW - Äthiopien KW - Angepasste Technik KW - Hygiene KW - water and sanitation KW - Ethiopia KW - appropriate technology Y1 - 2011 U6 - http://nbn-resolving.de/urn/resolver.pl?urn:nbn:de:hbz:836-opus-4843 PB - FH Münster ER -